|
In electronics, a current divider is a simple linear circuit that produces an output current (''I''X) that is a fraction of its input current (''I''T). Current division refers to the splitting of current between the branches of the divider. The currents in the various branches of such a circuit will always divide in such a way as to minimize the total energy expended. The formula describing a current divider is similar in form to that for the voltage divider. However, the ratio describing current division places the impedance of the considered branches in the denominator, unlike voltage division where the considered impedance is in the numerator. This is because in current dividers, total energy expended is minimized, resulting in currents that go through paths of least impedance, therefore the inverse relationship with impedance. On the other hand, voltage divider is used to satisfy Kirchhoff's Voltage Law. The voltage around a loop must sum up to zero, so the voltage drops must be divided evenly in a direct relationship with the impedance. To be specific, if two or more impedances are in parallel, the current that enters the combination will be split between them in inverse proportion to their impedances (according to Ohm's law). It also follows that if the impedances have the same value the current is split equally. ==Current divider== A general formula for the current ''IX'' in a resistor ''RX'' that is in parallel with a combination of other resistors of total resistance ''RT'' is (see Figure 1): : where ''IT'' is the total current entering the combined network of ''RX'' in parallel with ''RT''. Notice that when ''RT'' is composed of a parallel combination of resistors, say ''R1'', ''R2'', ... ''etc.'', then the reciprocal of each resistor must be added to find the total resistance ''RT'': : 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Current divider」の詳細全文を読む スポンサード リンク
|